Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Gate Repair Across Marco
Gate repair in Marco usually means one of two things: a gate that won’t open at all, or a gate that opens slowly, sticks halfway, or sounds like it’s grinding itself to death. Either way you want a technician who knows the salt-air realities of this island, not someone reading a manual for the first time. We work throughout 34146 and know the specific failure patterns in Marco’s developments. Call (844) 791-3898 and we’ll diagnose the problem over the phone before we ever roll a truck.
Why Courtyard Gate Repair Is Marco’s Preferred Gate Repair Company
We’re gate specialists. Not fence companies. Not handymen with a welder in the back of a pickup. Every tech on our team works on gates full time, and that narrow focus matters when a Viking board fails intermittently or a Ghost Controls arm loses its limit settings. Marco homeowners call us because we identify the actual failure rather than quoting a full replacement out of habit.
Noel Braddock runs our team with a simple rule: diagnose first, quote honestly, and match the gate’s original look whenever an HOA is involved. That matters on Marco, where design-review boards hold real authority over finishes and hardware styles. We’ve worked driveways along Collier Boulevard, the gated communities south of San Marco Road, and canal-front properties off Barfield Drive. The same corrosion patterns show up everywhere salt air reaches.
We arrive with the parts likely to matter on a barrier island: stainless fasteners, corrosion-inhibited hinges, sealed keypads, and operator boards for DoorKing, Elite, and LiftMaster systems. Our Gate Repair team stocks for salt-heavy environments specifically, which means fewer second visits for Marco customers.
Styles & brands we work with
Commercial Gate Repair in Marco
Commercial Gate Repair on Marco tends to mean condo communities, small office plazas on Collier Boulevard, and professionally managed estates with shared entry systems, not rolling industrial gates. These are low-cycle or medium-cycle systems compared to an apartment complex in Naples, but salt and humidity work on them the same way. A DoorKing slide operator near the water ages faster than the same unit installed ten miles inland.
Condo and HOA Entry Systems
Marco’s condo associations run mostly slide gates and swing gates with keypad or phone-entry systems. When a board corrodes, the gate stops hearing the keypad, and a resident has to wave a remote out the window or call the office. We replace boards, reprogram entry codes, and reseal housings against the next season of humidity. Typical board replacement on a DoorKing or Elite system in Marco runs $350 – $700, including programming.
Estate Driveway Gates
What’s called commercial on the invoice is often a large residential estate entrance. Canal-front and beach-access properties run heavier ornamental iron gates that require hinge and post work more often than inland homes. These repairs in Marco typically cost $250 – $900 depending on hinge count and post condition, with extra when finish matching is required.
Iron Gate Repair in Marco
Iron Gate Repair on Marco is largely about corrosion control. Ornamental iron looks permanent, but the salt-laden air off the Gulf attacks welds, hinge barrels, and the bottom rail where sprinkler water sits. Powder coat peels after a few intense summers, and once bare metal shows, the rust cycle starts within a season. Our iron work addresses both movement and metal: rehanging, reweld, and refinishing.
Weld and Hinge Restoration
We regularly cut out failed welds on Marco gates and reweld with proper preparation and zinc-rich priming. Hinge barrels freeze when salt crystallizes inside the sleeve; we replace them with stainless or marine-grade alternatives. Typical weld repair plus hinge replacement runs $180 – $500 per gate depending on access and finish requirements. Salt-damaged posts often need cutting back and new plate steel set in, which pushes a repair toward $600 – $1,000.
Rust Remediation and HOA Finishes
Marco’s HOAs usually require a repaired gate to match the original color and sheen. That means prepping to bare metal, reapplying the matching powder or paint system, and blending the repaired section into the rest of the gate. We’ve matched blackened bronze gates in Lely Resort and white-painted aluminum gates throughout Verona Walk. Finishing work adds $150 – $400 to a repair, but it’s what keeps a Board president from flagging the gate at the next meeting.
On a canal-front lot off South Barfield Drive, our crew repaired a LiftMaster swing gate operator that had corroded circuit board terminals from salt air, causing intermittent opening. We replaced the board, switched to stainless steel fasteners, and applied a corrosion inhibitor to the housing. We also adjusted the limit switches and tested the safety photocell to ensure UL 325 compliance, restoring reliable operation while matching the original finish.
Trusted Brands We Service in Marco
Your brand. Our expertise. We service DoorKing and Elite on the commercial side, and Ghost Controls and Viking on residential swing and slide systems, along with LiftMaster, FAAC, BFT, Linear, and Mighty Mule. Nine brands means we don’t steer you to one manufacturer to make our lives easier. We stock boards, limits switches, remotes, and receivers for DoorKing and Elite specifically, since Marco’s condo and HOA systems lean heavily on those two.
See the difference
Before
After
Before
After
Before
AfterCommon Gate Repair Problems We See in Marco Homes
- Sagging gates from corroded hinge posts. Salt air works into the hinge-to-post connection, the post rusts at the base, and the gate drops. The latch misses, the operator strains, and the whole system ages early. We reset posts in fresh concrete and use sacrificial anode coatings on the buried section.
- Intermittent operator failure from salt fog. Boards and keypads in Marco fail from corrosion, not age. A keypad on a Gulf-side driveway lasts three to five years against salt exposure. We replace with sealed units and dielectric grease on all terminals.
- Dead safety photocells and edge sensors. UL 325 requires functioning entrapment protection, and salt crust on photocell lenses kills them quietly. The gate stops closing or reverses constantly. We clean, re-aim, or replace the pair, then run the full test cycle.
- Peeling powder coat and rail rust. Intense sun fades finishes and salt accelerates the failure. Once water gets under the coating, rust spreads fast. We strip, treat, prime, and repaint or powder coat to match the original HOA-approved finish.
Pricing for Gate Repair in Marco, FL
Gate repair in Marco runs on predictable ranges, and you’ll get a written quote before any work starts. Hinge replacement runs $180 – $500 per gate. Operator board replacement runs $350 – $700. Weld repair, including prep and finishing, runs $250 – $900 depending on scale. Full rust remediation with HOA finish matching runs $600 – $1,200. No surprises: the price we quote is the price you approve, and nothing starts until you say go. Call (844) 791-3898 for a free estimate, and we’ll price your exact gate and operator over the phone when possible.
We Also Serve Cities Near Marco
Our Gate Repair in Marco coverage includes the whole island, plus nearby communities across the bridge. We regularly drive to Marco Island, Lely Resort, Verona Walk, and Lely, which means most South Naples and East Naples addresses are within a short drive of our techs.
Serving Marco, FL — Our Local Coverage Area
We’re based in the Marco area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Marco
Salt air corrodes uncoated steel hinges, hinge posts, and circuit board terminals within three to five years on Marco Island. Hinges seize as salt crystallizes in the sleeve, posts rust at ground level, and board contacts oxidize until the operator works intermittently or not at all. We replace failed hardware with stainless or marine-grade equivalents and treat exposed boards with corrosion inhibitor. Call (844) 791-3898 to have your gates checked before a failure strands a car in the driveway.
Your gate sags because the hinge post has corroded or shifted, which drops the gate and causes the latch to miss. Almost always, yes, it can be fixed without replacing the gate. We reset and resecure the post, replace worn hinges, and realign the leaves. Most sag repairs in Marco run $180 – $500 per gate. If the bottom rail is rusted through, we section in new steel and match the finish, which costs more but still beats a full replacement.
Yes, UL 325 requires entrapment protection on every automated gate: photocells, reversing edges, or both, depending on the gate type and operator. Marco’s salt air cakes photocell lenses and degrades sensor wiring faster than inland, so we test and often replace these on nearly every service call. After any repair we run the full UL 325 test cycle, including obstruction and reverse checks. Call (844) 791-3898 to schedule a compliance inspection.
Yes, we match the gate’s original finish by prepping to bare metal and reapplying the same powder or paint system and sheen. Marco HOAs, especially in developments along Winterberry Drive and the canal neighborhoods, typically require repairs to be visually indistinguishable from the original. We document the existing finish before starting and blend the repair area into the surrounding surfaces. Finish matching adds $150 – $400 to a typical repair, and we’ll confirm the HOA’s requirements with you before quoting.
Washing your gate and operator housing with fresh water monthly, applying a corrosion inhibitor to exposed metal, and having hinges and photocells inspected each spring prevents most salt-related failures on Marco. We offer maintenance visits that include hinge lubrication, board inspection, sensor cleaning, and post condition checks, usually $150 – $250 per visit. For canal-front or Gulf-side properties, we recommend twice-yearly service. Call (844) 791-3898 and we’ll set up a reminder schedule.
If your gate is down, slow, or making noise it shouldn’t, call Courtyard Gate Repair at (844) 791-3898. We’ll talk through what’s happening, give you a straight answer on cost, and set up a time to fix it. Free estimates. Written quotes. No work starts until you approve the number.
Written by Noel Braddock, Owner at Courtyard Gate Repair, serving Marco since 2019.