Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Electric Gate Repair Across South Sarasota
Electric gate repair in South Sarasota typically runs $185 – $520 depending on whether we’re replacing a corroded control board, a seized hinge post, or a failed motor. Most repair calls in the 34231 area are diagnosed and fixed same-day, though post-storm weeks can push scheduling out a day or two. If your gate is stuck open, stuck closed, or grinding itself to death, call us at (844) 791-3898 and we’ll get a technician out to your driveway.
We know South Sarasota’s gates because we’ve worked on hundreds of them. The 1950s and 1960s ranch homes off Tamiami Trail, the canal-front properties with boat lifts, the short dead-end streets between Swift Road and the Intracoastal. These aren’t new-build communities with standardized gate packages. They’re older homes with older gates, and that’s exactly what we’re built to handle.
Why Courtyard Gate Repair Is South Sarasota’s Preferred Electric Gate Repair Company
South Sarasota homeowners call us because we’re gate specialists, not generalists. Every technician on our team works on gates every single day. We don’t split our time across garage doors, fences, decks, or whatever else walks through the door. That means when we pull up to a South Sarasota home with a dead DoorKing operator, we already know the board layout before we open the panel.
We service nine major operator brands: LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. When a South Sarasota property manager tells us their complex runs a FAAC 400 on the entry and a BFT on the pedestrian gate, we don’t blink. We stock parts and boards for all of them, which shortens repair time significantly for our 34231 customers.
Our local reputation in South Sarasota is built on honest diagnosis. We repair what others replace. If your lift motor has a bad capacitor, we replace the capacitor. If your control board is genuinely fried beyond salvage, we’ll tell you straight, and give you the retrofit and replacement options side by side so you can decide with real numbers.
Styles & brands we work with





Gate Access Control in South Sarasota
Gate Access Control in South Sarasota covers the entry systems that decide who gets in: keypads, telephone entry units, vehicle detectors, intercoms, and the wiring that ties them to the operator. On older South Sarasota properties, many of these systems are original to the home, which means we’re frequently working with keypads that have cracked housings from two decades of UV exposure and intercoms that haven’t worked since the last big storm.
Keypad and Intercom Retrofits
South Sarasota’s salt air does a number on outdoor keypads. The membrane buttons crack, moisture creeps into the circuit board, and suddenly your code only works every third try. We can often save the operator and replace just the keypad assembly, or upgrade you to a wireless model that doesn’t depend on buried conduit. When we retrofit, we use weather-sealed enclosures rated for coastal exposure, not the inland-rated units you’d get off a shelf in a big-box store.
Telephone Entry and Safety Sensors
On canal-front South Sarasota properties where the gate is far from the house, telephone entry systems save a long walk. But the phone lines and power runs near the water fail faster than anywhere else. We test the whole circuit from the house panel to the gate post, identify where the fault is, and replace only what’s needed. Same with safety sensors: the photo eyes on a South Sarasota gate get caked with salt residue and stop communicating, which the operator interprets as an obstruction. Sometimes the fix is a cleaning and realignment; sometimes the sensor itself is dead. We check before we sell you parts.
Commercial Gate Operator in South Sarasota
Commercial Gate Operator work in South Sarasota spans the apartment complexes, storage facilities, and small office parks between Bee Ridge Road and the Intracoastal. These are high-cycle systems: the gate opens fifty or a hundred times a day, and the operator takes a beating that residential units never see. When a commercial operator fails, it’s rarely the brand-new one that was just installed. It’s the one that’s been running since the property was built, with a control board that’s no longer manufactured.
High-Cycle Operator Repair and Replacement
South Sarasota’s commercial gate operators run hard in the summer thunderstorm season. Humidity gets into enclosures, thermal cycling stresses solder joints, and one afternoon a boom barrier just stops lifting. We carry boards and motor kits for DoorKing, FAAC, BFT, and Elite commercial operators, so we can usually rebuild an existing operator rather than quoting a full system replacement. When the operator genuinely is beyond service, we’ll quote the replacement honestly, including the labor to re-run sensor wiring and reactivate the safety edges.
Slide Gate Track and Roller Alignment
South Sarasota’s commercial slide gates are exposed to wind loads that inland operators never face. A 60 mph gust shoves against a 20-foot cantilever gate, and over time the rollers wear unevenly, the track shifts, and the gate starts binding. We realign the track, replace worn rollers with sealed bearings, and check the end stops. For canal-side properties, we’ll also recommend stainless fasteners on any hardware that sits within salt spray reach.
Trusted Brands We Service in South Sarasota
Courtyard Gate Repair is brand-agnostic. Your brand. Our expertise. Whether you have a LiftMaster swing arm on a 1970s ranch in South Sarasota, a Mighty Mule on a newer build off Bee Ridge, or a DoorKing on a commercial entry, we know the failure points and the parts. Because gates are the only trade we do, our parts inventory runs deep. We stock control boards, limit switches, photo eyes, and receivers for all nine major brands, which means we rarely have to order a part and come back a week later. For our South Sarasota customers, that’s the difference between a gate that’s down for an afternoon and a gate that’s down for a month.
See the difference
Before
After
Before
After
Before
AfterCommon Electric Gate Repair Problems We See in South Sarasota Homes
- Original operators with boards that are no longer made. South Sarasota’s 1950s – 1970s housing stock means we see a lot of gates that were installed when the home was built. The operator might be a brand that still exists, but the control board inside it was discontinued years ago. We can often retrofit a universal board or rebuild the existing one, and we’ll walk you through the cost comparison before we touch anything.
- Swing gates sagging at the hinge post. On older South Sarasota gates, the hinge post is often the original pressure-treated wood or light steel, and decades of salt air and storm cycles have done their work. The gate drops, drags, and eventually the operator motor burns out from fighting the misalignment. We correct the post, not the panel, because patching the middle of the gate just moves the problem six months down the road.
- Photo eyes and safety sensors blinded by salt residue. The same salt that pits your gate’s powder coat builds up on the sensor lenses. A gate that reverses for no reason or refuses to close is often just a dirty or degraded sensor. We test the whole safety circuit, clean what’s cleanable, and replace what’s beyond cleaning.
- Post-storm gate failures. After a tropical storm rolls through South Sarasota, we get a wave of calls: slide gates off their tracks, swing gates twisted, operators that tripped their breakers and won’t come back. We know to check the track alignment first on slide gates, and the hinge post on swing gates, before we ever open the operator enclosure. Wind damage often looks electrical when it’s structural.
Pricing for Electric Gate Repair in South Sarasota, FL
Here’s what South Sarasota homeowners can expect to pay, based on the work we actually do in 34231:
- Control board replacement or retrofit: $220 – $480 depending on brand and whether we can source a rebuilt board or need to retrofit to a current model.
- Hinge post repair or replacement: $310 – $650 for a swing gate, including resetting the panel and re-aligning the operator.
- Photo eye or safety sensor replacement: $120 – $260 per pair, including alignment and testing.
- Keypad or intercom replacement: $140 – $390 depending on wired versus wireless and the condition of the existing conduit.
- Commercial operator repair: $360 – $1,100 for high-cycle DoorKing, FAAC, BFT, or Elite systems, parts and labor.
Every price is quoted and agreed before any work starts. You’ll know the number before we open a single panel. Estimates are free, and you can call (844) 791-3898 to get one scheduled.
We Also Serve Cities Near South Sarasota
Our electric gate repair coverage extends beyond the 34231 ZIP. We regularly take calls from Electric Gate Repair in South Sarasota customers in Gulf Gate Estates, Ridge Wood Heights, Siesta Key, and Bee Ridge. If your gate is down and you’re anywhere in the South Sarasota area, give us a call at (844) 791-3898.
Serving South Sarasota, FL — Our Local Coverage Area
We’re based in the South Sarasota area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Electric Gate Repair in South Sarasota
We can retrofit most obsolete boards, including many LiftMaster, DoorKing, and Elite models from the 1990s and early 2000s. The decision comes down to the condition of the motor and gearbox: if those are solid, a retrofit board costs $220 – $480 and buys you years more life. If the motor is also failing, replacement is the cheaper long-term answer. We’ll show you the numbers on both paths. Call (844) 791-3898 and we’ll diagnose it on site.
Because the hinge post is bearing the full weight of the gate plus wind loads, and on older South Sarasota homes that post is often original light steel or pressure-treated wood that’s been soaking in salt air for 40 or 50 years. The post itself moves, even a fraction of an inch, and the whole gate drops. Fixing it properly means a new post set in concrete with stainless hardware, not a mid-panel patch job. We do that repair in a day. Call (844) 791-3898 for a free assessment.
If your gate predates current UL 325 standards, it likely lacks the photo eyes, safety edges, and force-reversal features required today. Legally, the gate can remain if it was compliant when installed, but practically, a gate without entrapment protection is a liability, especially on canal-front South Sarasota properties where kids and pets are common. We can retrofit photo eyes and contact edges onto most older operators. It’s a $220 – $400 upgrade on average. Call (844) 791-3898 to have us look at your setup.
Salt spray from the Intracoastal and the bays around South Sarasota eats standard galvanized hardware within a season or two. The bolts on a dock gate sit in a constant salt film that never truly dries. We swap those out for 316 stainless, which holds up for years, not months. It’s a small cost difference on the bolts themselves, and it prevents the call you’re making right now from becoming an annual tradition. Call (844) 791-3898 if you want your dock gate hardware checked.
First we check the track itself: did the storm push the gate sideways enough to bend or shift the rail? Then we check the rollers, the cantilever arms, and the end stops. Wind loads on South Sarasota slide gates often bow the gate panel slightly, which makes it ride off the track even after you muscle it back on. We correct the panel, realign the track, and replace any rollers that took impact damage. If your gate’s down after a storm, call (844) 791-3898 and we’ll get out to you.
We were called to a canal-front home near the boat lift off a South Sarasota driveway in 34231 where a swing gate running an older LiftMaster operator had quit after an afternoon storm. The board was corroded and the hinge post had swelled, throwing the panel out of line. We replaced the failed control board, corrected the sag at the hinge post rather than mid-panel, and swapped the rusted dock-side fasteners for stainless so the gate would hold through the next blow. That’s the work we do every week in South Sarasota: not installing new gates nobody asked for, but fixing the ones that have been standing for decades and just need a specialist to keep them standing.
If your electric gate is down, unreliable, or making noises it didn’t make last year, call Courtyard Gate Repair at (844) 791-3898. We’ll diagnose the real problem, quote the fix before we start, and get your gate back to working, and staying that way.
Written by Noel Braddock, Owner at Courtyard Gate Repair, serving South Sarasota and the surrounding area.