Ghost Controls Gate Repair in Naples, FL

Ghost Controls Gate Repair in Naples, FL | Courtyard Gate Repair

Ghost Controls gate repair in Naples typically runs $165 – $425 depending on whether we’re replacing a corroded receiver board, a dead solar battery, or re-syncing dual arms, and most jobs are completed same day. We’re an independent repair shop serving zip codes 34105, 34106, 34107, and 34108, and the single biggest factor shaping Ghost Controls work here is salt air eating low-voltage electronics before mechanical parts ever fail. Naples gates sit close to the Gulf, and that proximity shows up in the control boards we open. Call (844) 791-3898 for a free estimate.

Call (844) 791-3898

Courtyard Gate Repair works on Ghost Controls solar and low-voltage swing operators every week across Naples, from single driveway arms in the older downtown grid to paired double-gate setups in Pelican Bay. We know their control boards, battery harnesses, and accessory wiring inside out. We are an independent repair shop – not authorized, sponsored, or endorsed by Ghost Controls – so our only job is getting your gate reliably opening again. That independence means we diagnose the actual failure instead of steering you toward a full operator replacement. If a board is toast, we say so. If it’s a $40 harness, we say that instead. Ghost Controls sales & service is a core part of what we do, but we’re not married to the brand. We’re married to the fix.

Why Naples Residents Choose Us for Ghost Controls Service

Gate specialists, not generalists. Every technician on our team works exclusively on gate systems, which means when we pull up to a Ghost Controls TDS series arm in Naples, we’re not figuring it out from a manual. We’ve seen it before. Noel Braddock, our owner, spent years working through every gate type Southwest Florida’s climate can throw at a piece of equipment: saltwater-corroded hinges, sun-cracked operator boards, post-hurricane alignment jobs that would make most contractors walk away. That experience shapes how we approach every Golden Gate Ghost Controls service call.

We repair what others replace. A Gate that stopped responding to the remote but still works from the keypad is usually a $90 receiver board, not a $700 operator. That’s the kind of diagnosis you get when the person on-site knows the difference between a board failure and a motor failure on a Ghost Controls arm. We stock genuine Ghost Controls control boards, battery harnesses, photo-eye kits, and remote accessories locally for fast Ghost Controls in Vineyards turnaround, and we pair them with quality aftermarket hardware for hinges, posts, and weatherproofing where the aftermarket part actually holds up better in coastal air.

Common Ghost Controls Gate Repair Problems We Solve in Naples

• Remote dead, keypad works. This is the most common Ghost Controls failure we see in Naples, and it’s almost always a corroded receiver module or board-level solder joint. Salt-laden air gets into the control enclosure, settles on the board, and the remote signal never reaches the arm. The motor is fine. The board is dying. We replace the board, seal the enclosure properly, and re-sync your remotes.
• Solar arm stalls mid-swing. Solar-powered Ghost Controls arms depend on a healthy deep-cycle battery. Two or three Naples summers of heat accelerates battery degradation, and once voltage sags under load, the board browns out and the arm stops halfway across the driveway. We test the battery under load, not just at rest, because a battery that reads 12.8 volts sitting still can drop to 9 volts the moment the arm pulls current.
• Dual-swing gates falling out of sync. Ghost Controls TD2 and TDS2 paired-arm kits rely on synchronized limit settings. When one gate post shifts, which happens with the sandy, settling soil in older Naples neighborhoods, the arms fight each other and the master board sees a fault. We correct the geometry, reset limit switches, and re-sync the pair so both leaves open and close as one.
• Lightning and storm-surge damage to accessories. Afternoon thunderstorms in Naples don’t just soak your gate. A nearby strike sends a surge through low-voltage accessory wiring and knocks out keypads, intercoms, or photo-eye circuits without touching the operator motor at all. We trace the accessory runs, replace damaged modules, and install proper surge protection on the low-voltage side so the next storm doesn’t repeat the job.
• Arm binding on a sagging post. In the older downtown grid and 1950s – 70s ranch neighborhoods, gate posts have been in the ground for decades. When a post leans even slightly, the Ghost Controls arm binds against its own stroke, the motor strains, and the operator reverses or throws a limit error. The fix is post correction first, then arm realignment. Replacing the operator without fixing the post just burns out a new motor.

Ghost Controls Service in Naples: What Local Conditions Mean for Your Equipment

In Pelican Bay and similar association-controlled communities, Ghost Controls arms often sit on gates that must be repainted in HOA-approved colors. That single requirement changes how repair work plays out here in ways a generic gate company never considers. A motor or arm swap on a Pelican Bay driveway gate isn’t just a mechanical job. We have to coordinate paint specs with the association manager before we button up the enclosure, match the hardware finish to whatever the HOA board approved, and sometimes work around access-control systems that were specified by the community rather than the homeowner. A gate repair that might take two hours in a non-HOA neighborhood can add a layer of coordination here, and we handle that coordination because we’ve done it often enough to know which questions to ask before we start. Naples is a community of private, gated enclaves – from Port Royal to Pelican Bay – where gates are the primary security layer, and association managers care as much about how the repair looks as whether it works. We account for both.

Ghost Controls Models & Products We Service in Naples

We service the full Ghost Controls residential line. That includes the Heavy-Duty Single Swing TDS series, the Dual Swing TD2 and TDS2 paired-arm kits, the Standard Duty TS and TS1 single swing arms, and the accessory line: AXDP keypads, ABB battery boxes, photo-eye kits, and remote packages. When we replace a Ghost Controls part, we use genuine Ghost Controls boards, arms, batteries, and harnesses where fit and function demand it. For hinges, posts, and weatherproofing, we’ll use quality aftermarket hardware that holds up better against Naples salt air than some OEM iron. Our local parts stock covers the most common Ghost Controls boards, batteries, and receiver modules, so a Ghost Controls service in Lely usually doesn’t wait on a parts shipment.

Ghost Controls Service Pricing in Naples

Ghost Controls repair costs in Naples vary by what actually failed. Receiver board replacement runs $165 – $285. Solar battery replacement is typically $120 – $220 including the battery. Dual-arm re-synchronization or limit-switch corrections fall between $140 – $260 per gate. Full arm or operator replacement on a heavy-duty TDS series unit ranges from $485 – $850 depending on the model and whether we’re doing one arm or a paired setup. Every estimate is free, and we quote the exact price before any work starts. You’ll never get hit with a surprise invoice after the fact. Call (844) 791-3898 for an exact quote on your Ghost Controls system, and we’ll tell you straight what the fix costs.

FAQs – Ghost Controls Gate Repair in Naples

Service Areas Near Naples

In addition to Naples, we provide Naples service area coverage across Southwest Florida, including Fort Myers, North Fort Myers, and the surrounding communities. For clients east of town, we offer dedicated Ghost Controls service in East Naples, and we also serve Ghost Controls service in Grove City for those just up the coast. Wherever your gate sits, we’ll come to it.

Book Your Ghost Controls Service in Naples Today

A gate doesn’t fail all at once – it tells you what’s coming if you know what to look for. If your Ghost Controls gate is hesitating, stalling, or ignoring the remote, don’t wait for the morning it refuses to move. Call (844) 791-3898 for a free estimate, and we’ll get your gate back to working – and staying that way.

Written by Noel Braddock, Owner at Courtyard Gate Repair, serving Naples and Southwest Florida.